This jumpers are typically used for bonding equipment to a common ground buss bar. They are an especially good choice for RF applications.

Our stock jumpers are available in three standard hole patterns, designated with an A, B, or C suffix in the part number.

A. 1/4" hole on both ends.

B. 3/8" hole on both ends.

C. 1/4" hole on one end 3/8" hole on the other.
AN IMPORTANT NOTE ABOUT HOLE SIZES...Holes are slightly oversize for easy connection.1/4" holes are actually 0.281" diameter.3/8" holes are actually 0.406" diameter.

Length is measured center-of-hole to center-of-hole.